***
NOTE - 
For safety - ALWAYS disconnect the battery Earth lead before working on the starter motor!! 
***

Changing the 2.2 starter.

It will be necessary to remove the two support braces for the intake
manifold for access. There are one or more front support bolts and brackets that
are removed.

All three of the main mountbolts are on the back side of the
engine/transmission "bell housing", the two lower ones accessible from under the
vehicle ( come in behind the left front wheel) the other one is accessible
after removing the center front access panel, under the radio area thru the
firewall. 

The bolt is a little hard to get to, is pretty tight and there isn't
much clearance to work with but can be done..

Leave the wiring alone till you are ready to drop the starter. Last thing is
to remove the wiring. This is a good time to install a starter trigger lead
booster (Solenoid off the battery to the start solenoid trigger, controlled
by the old trigger wire).


To install the starter, get it into position, connect the wiring,then
install the bolts Be sure to get the locator sleeve (pilot bushing) installed in
the lower starter mount hole and toque the three bolts before installing and
torquing the front support brackets and bolts.

Give yourself a lot of time, this job will test your patients and religion.
Been there, done that!

LarryS